A proper installation of polycarbonate sheets requires the use of the elements necessary to get the job done. We offer a complete range of aluminum or polycarbonate profiles , sealing and anti-dust tapes , screws … Our patent protected Hermitage system exhibits superior elegance and ensures high capacity to withstand loads.
Hermitage intermediate profile
This combination of structural and decorative elements with appropriate gaskets enables joining and sealing of two polycarbonate sheets.
For sheets: 10 / 16 / 20 / 25 mm
Hermitage end profile
This combination of structural and decorative elements, with appropriate gaskets enables outer rim sealing of the sheet.
For sheets: 10 / 16 / 20 / 25 mm
Hermitage corner coupler
Corner joint of two Hermitage elements without visible screws.
For Hermitage: 10 mm
Hermitage T joining element
T joint of two Hermitage elements without visible screws.
For Hermitage: 10 / 16 / 25 mm
Hermitage MINI
Solid polycarbonate sheet; improved abrasion, chemical and UV resistance; available transparent and bronze.
For sheets: 10 mm
Hermitage gasket, top and bottom
Used to fix polycarbonate sheets to the Hermitage profile frame - no-sheet-drilling system enables thermal expansion and excellent sealing.
For Hermitage: H10 / H16 / H25 mm
Aluminium roofing profile with two gaskets
Placed on the joint of two sheets allows for a quality connection with the support structure, sealing and expansion of sheets whereas preventing water penetration.
Dimensions: universal
Bottom gasket
Made of EPDM, hardness 65 Shore A mounted to the substructure and allows for quality joint of two sheets.
Dimensions: 60 mm
Decorative aluminum profile
This decorative element is built in by being pulled over an Al cover profile - hides the screw connection and protects it from moisture.
Height: 15 / 60 mm
Screws and washers
Specially selected washers coated with stainless steel on the top and neoprene (EPDM) rubber on the bottom side provides quality sealing and dilatation of the sheets while preventing water penetration.
Screws: 4.8 / 5.5 / 6.3 mm
Washers: 22 / 29 mm
F aluminium profile
Placed at the sheet ends over AntiDust tape, protecting it from external influences and forming a slight drip.
For sheets: 6 / 10 / 16 / 25 mm
F aluminum profile 5/10
Placed at the sheet ends over AntiDust tape, protecting it from external influences and forming a slight drip.
Dimensions: universal - for sheets 5 / 10 mm
U aluminum profile with mini drip
Easy and economical, performing a double role - closes the ends of the sheet and forms a small drip.
For sheets: 10 mm
U aluminium profile
Placed at the sheet ends over AntiDust tape, protecting it from external influences.
For sheets: 10 / 16 mm
AntiDust filter tape and AntiDust tape
Filter tape closes sheet chambers, allows for single-direction moisture drainage i.e. from the sheet out. AntiDust closes the sheets and prevents the ingress of water, moisture and dirt.
Width: 25 / 38 mm
Sealing tape
Placed between polycarbonate and steel structure, in places where two sheets are not joined - prevents direct sheet-steel contact so eliminating unpleasant sounds.
Width: 20 / 40 mm
LPU profile
Made of transparent polycarbonate it seals the sheet along the outside rim. The standard length 2.1m.
For sheets: 6 / 8 / 10 / 16 mm
LPH profile
Made of transparent polycarbonate it is used to join the sheets, standard length of 6m.
For sheets: 6 / 8 / 10 / 16 mm
